Thank You For the Gift

  • Difficulty Rating: Beginner
Thank You For the Gift

Say thank you for a gift in a bright, fun, bold, yet simple way using the Fuse Creativity System® and strips of patterned paper notched to look like ribbons.

1. Begin with a 12 inch x 6 inch piece of black cardstock folded to 6 inches x 6 inches.

2. Cut six 1 inch wide strips of patterned papers, notch one end with the Fiskars No. 5 Micro-Tip Scissors. Line the front of the card from top to bottom with the strips, allowing them to hang over the side of the card if desired. Cut a 2.5 inch x 6 inch strip of coordinating patterned paper and mount it over the ribbon strips.

thank you card 1

3. Because the elements that make up the design of this plate are separate, using multiple colors of ink is a breeze. Mount the letterpressed diecut over the strips of paper on the card front.

thank you card 2

4. Again using the scissors, cut a decorative element from a sheet of patterned paper and mount it on a scalloped circle created using the Fiskars Extra-Large Seal of Approval Squeeze Punch.

5. Finish the card off by punching a 6 inch strip of black cardstock using the Jenni Bowlin Jester Border Punch and mount it to the left-hand side of the card.

Supply List

6 inch x 12 inch piece of black cardstock

Variety of patterned paper scraps