Upcycled Wine Cork Pendants
By Lisa Storms
- Ideal for stamping craft projects like scrapbook pages, cards, invitations, collages and more with a variety of stamp sizes
- Clear design lets you see where you’re stamping
- Grid lines provide easy alignment
- Includes convenient carrying case, perfect for the crafter on the go
- Works with a wide variety of clear stamps
- Sizes: 1" x 1", 2" x 2", 3" x 3", 2" x 6"
- Excess ink washes off the blocks easily with stamp cleaner or a solution of mild soap and water
- Lifetime warranty
- Stamp Block Set
- Ideal for adding textured designs to scrapbook pages, cards, invitations or other craft projects
- Two-sided plates offer a total of 12 designs
- Works with standard paper, cardstock, foil, vellum and more
- Great for use with our Texturing Tool or Embossing Stylus
- Each plate measures 5.75" x 7"
- Lifetime warranty
- Texture Plates - 6pk Asst. III
Four different sizes of traditional stamp blocks offer excellent stamping versatility.
Six double-sided plates give you a total of 12 great designs.
Fiskars’ new line of stamps by Teresa Collins is absolutely beautiful, and definitely fit to be worn as jewelry.
Here’s how to make your own:
1. Cut wine corks into slices at desired widths using a knife or small saw. This time I thought to use the bench vise we have out in the garage, but I’ve sliced many corks without one. Just be sure to be very careful keeping your fingers away from the blade and work on a protected surface.
2. Sand the cork slices to create a flat surface.
3. Paint or ink the flat surfaces if desired (play around with and without color) and allow them to dry fully.
4. Stamp image onto front of slice. You do not need to use an image that is small enough to fit. Try stamping partial images as I’ve done here, such as stamping inside the wheel of a bicycle stamp or the edge of a doily stamp.Tip: Since the corks are small, press them into the stamp instead of stamping onto the slice. Add a pattern before your stamp by painting onto a texture plate and pressing cork slice onto plate like this honeycomb design.Allow them to dry fully before stamping over pattern.
5. Screw a 5mm eye screw into the top of each slice for hanging. You can hang from a necklace with this loop, or you may need to add a small jump ring to fit over clasp.
Make a bunch to swap out on a necklace so you’ll always have something fun to wear with any outfit!